Chinese translation for "amorphous phase"
|
- 非晶相，无定形相
非晶形相
无定型相；非品相
无定形相
Related Translations:
amorphous: 玻璃态的非定形的 非晶 非晶态的 非晶质的非结晶的，无定形的非结晶质的非晶的,非晶形的,无定形的非晶的；无定形的松散的无定形的，非晶体的无定形的；非晶的；无一定方向的无定形的；非品态的无定形的；难以名状的无体型的无形状的无组织的
- Example Sentences:
| 1. | Formation of amorphous phase in binary immiscible cu - ta system
体系非晶相的形成 | | 2. | With the increase of its thickness , the single film transforms crystal phase into amorphous phase
单层膜随着厚度的增加呈现非晶态， 1000nm以上为完全非晶态。 | | 3. | The amorphous phase is formed from the transformation of super - saturate solid solution , and there is no nuclear formation and grow process
非晶相的形成是通过超过饱和固溶体的失稳转变而成，不存在形核与核长大过程。 | | 4. | The sample is amorphous phase at the thickness 1000 nm , however , its soft magnetic properties gradually become worse . the phenomenon originates mostly from the thermal stress
膜的软磁性能随厚度的增加迅速变差，认为是热应力太大造成的。 | | 5. | The grain size of - fe decreased with increasing milling time , the nd - fe - b alloy powders was composed of amorphous phase nd2fe14b and - fe with average grain size of about 10nm after milling 5 hours
随球磨时间的延长, nd2fe14b和- fe的晶粒尺寸逐渐变小, nd2fe14b相迅速分解直至消失,基本上转化为非晶相。 | | 6. | ( 5 ) the structures of samples obtained by ball milling were also related with the milling intensity ( power ) , which indicated that the lower milling power was in favor of the formation of amorphous phase
（ 5 ）球磨强度的大小对产物的组成也有影响，相对较低的能量有利于非晶相的形成。本实验中，机械合金化作用下，球磨体系（ sts 。 cs 。 | | 7. | Consisted mainly of amorphous phase . hrem images showed that the ti - dlc film had a lamellar structure . the tic phase with a size of 5 nm was located at the titanium - rich regions surrounded by amorphous carbon structures in the ti - dlc film
Ti - dlc膜的结构主要为非晶相,高分辨电子显微镜分析( hrem )表明ti - dlc膜成层状分布,膜内存在着富ti区和贫ti区, tic颗粒尺寸大约为5nm 。 | | 8. | The results show that titanium oxide films prepared at room temperature consist of amorphous phase of titanium oxides , which can transform to crystal phase mainly consisting of anatase and rutile when they are subjected to appropriate heat treatment
实验结果表明，本文采用电化学方法制备的氧化钛膜是一种非晶态膜，对其进行适当的热处理后，膜的结构主要由锐钛矿和金红石组成。 | | 9. | The unstable solid solution would disintegrate and transform into carbide phases in these systems of sisocso , tisocso and zrsocso , based on the increase of free energy introduced by the effect mechanical alloying . for the system of wsocso , the solid solution had not transformed into tungsten carbides but an amorphous phase , which was different from those systems . the exist of fe in these experiments , which came from the abrasion of ball - milling tool because of the higher hardness of w and w - c solid solution , would induce the crystalline - to - amorphous phase transformation during milling
C50球磨体系中，继续球磨时，不稳定的固溶体在机械合金化作用下，由于体系能量提高，会发生分解相变，从而可以形成碳化物；对于w扣c50球磨体系， w ? c固溶体具有较高的硬度，磨削不锈钢质的球磨介质和球磨容器，而引入杂质，其中fe会促使固溶体向非晶相转变。 | | 10. | By increasing the h2 dilution ratio , it is found that atomic hydrogen can selectively etch amorphous phase and stabilize crystalline phase . from the study on the distance from substrate to catalyzer , choosing a proper distance can ensure the gas fully decomposed , while a relatively low substrate temperature can cause the nanocrystalline particles to lose mobility and keep their sizes . the pre - carbonization process can enhance the nucleation density and make the growth of high quality nanocrystalline p - sic films much easier
实验结果表明：随着工作气压的减小，薄膜的晶粒尺寸有所减小；通过提高氢气稀释度，利用原子氢在成膜过程中起的刻蚀作用，可以稳定结晶相并去除杂相；选择适当的热丝距离能保证反应气体充分分解，又使衬底具有较高的过冷度，是形成纳米薄膜的重要条件；采用分步碳化法可以提高形核密度，有利于获得高质量的纳米- sic薄膜；衬底施加负偏压可以明显提高衬底表面的基团的活性，因负偏压产生的离子轰击还能造成高的表面缺陷密度，形成更多的形核位置。 |
- Similar Words：
- "amorphous orientation" Chinese translation, "amorphous oxide film" Chinese translation, "amorphous particle" Chinese translation, "amorphous peat" Chinese translation, "amorphous personality" Chinese translation, "amorphous phosphate" Chinese translation, "amorphous phosphorus" Chinese translation, "amorphous physics" Chinese translation, "amorphous plasticity" Chinese translation, "amorphous plastics" Chinese translation
|
|
|
